Here are the pin assignments on the Orange OpenLRS Receiver (note the CTS line does not need to be connected):
Solder the connector to the Parallax XBee adapter board as follows:
Thursday, March 20, 2014
Adapting Parallax XBee USB FTDI Adapter for programming OpenLRS Radios
I was in need of an FTDI adapter to program an OpenLRS radio, and had an XBee USB adapter on hand...this had the FTDI chip I needed, all I had to do was wire up a connector, and I was set to go.
Here are the pin assignments on the Orange OpenLRS Receiver (note the CTS line does not need to be connected):
Solder the connector to the Parallax XBee adapter board as follows:
Here are the pin assignments on the Orange OpenLRS Receiver (note the CTS line does not need to be connected):
Solder the connector to the Parallax XBee adapter board as follows:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment